Johnsons Christmas Corner

Your Home For Holiday Fun In Cypress, Spring & Tomball

North Poles

We created North Poles years ago and used them in two different ways:

Down the Sidewalk:
Walkway

North Poles Installed

NorthPolesLighted

Around the perimeter of the yard:

SidePoles1

They’re a relatively inexpensive and good-looking decoration to use.


Step 1:  The materials below are all you’ll need:

Step A

–  4” wide PVC pipe cut to a two foot length. ($10 for 10 feet)

–  4” wide PVC collar ($2.00)

–  6” plastic globe ($5.00)

–  6 foot brown SPT2 extension cord

–  Porcelain lamp holder ($2.00)

–  15 watt bulb ($3.00 for  two)

–  1” blue painter’s tape ($3.00)

–  Fire Truck Red Plastic Spray Paint ($5.00)


Step 2:

Sand the printing off of your tube (use fine paper and no electric sander- you could tear up your tube!)

Wrap your PVC pipe with blue painter’s tape to create a “candy cane pattern”.  You can use different size tapes if you’d like to create a more realistic effect.

Step B Step C

Spray the tube with your red spray paint.

Step D


Step 3:

Wait for the paint to dry.  Pull off the tape carefully (left) to reveal your candy cane pattern” (right):

Step E  Step F


 

Step 4:

Get your collar (left), use your spray paint (middle), to make it look like the final collar (right).

Step G


Step 5:

Take your extension cord and clip off the female end. NOTE: Many people reuse these ends on other projects so cut about an inch or two from the plug.

Step H


Step 6:

Drill a 5/16” hole six inches from the bottom.  Run your wire through it up to the top of the pole.

Step L


Step 7:

Strip ½” of the wire, screw down to the terminals.  Plug in to test.

Step J  Step K


Step 8:

Place the light fixture on top of the tube (you can add a junction box to the bottom of it if you choose).  Regardless, it will fit inside of the 4” PVC tube).  At that point, you should place the 4” collar over the tube and light fixture.  This will hold the light fixture snug between the collar and the tube.

Step M Step N


Step 9:

This picture on the left shows what your pole should look like at this point. Now you should place the globe over it:

Step O Step P


Step 10:

Place a small amount of silicone around the globe edge.  Do not use too much silicone, for 2 reasons:  First, it’s simply unattractive.  Second, it is easier to simply twist the globe and break the silicone if/when you need to change the bulb.

Step R

You’re Done!  Make a bunch and have fun!